The newest OBDII Interface from HP Tuners allows you to connect your
vehicle’s various supported control modules to the HP Tuners VCM Suite.
The VCM Suite will allow you to read, diagnose, and clear trouble
codes, while allowing you to pull the vehicle’s stock file and modify
it. The possibilities are limitless with the ability to optimize your
vehicle’s performance, fuel economy, torque response, and more.
What’s new with the MPVI3?
- Now comes standard with the Pro Feature set ( Pro Link cable sold separately)
- Faster standalone datalogging
- Improved storage (8 MB/s over the MPVI2+ 4 MB/s)
- High-resolution accelerometer
the legacy of its predecessor with features like Bluetooth 5.0, an M8
motorsports-grade screw-on connector, RGB LEDs, and USB-C connectivity.
Get equipped with the most inclusive scanning, logging, and calibration package in the industry. Connect > MPVI3 is an advanced OBDII interface tool, connecting your vehicle’s control modules to the VCM Suite software. Read > Run complete diagnostics, monitor vehicle performance, read from various vehicle control modules, and more in VCM Suite. Edit > Optimize
your performance, fuel economy, or whatever your vehicle goals may be
in VCM Editor with a multitude of defined parameters. Write >
When you are ready, license and tune any vehicle currently supported by
HP Tuners with the fastest read and write speeds available. Drive >>>
dedicated race cars to tow rigs, off-road machines, next-level street
cars, and fuel-efficient daily drivers, HP Tuners delivers the ultimate
solution for builds and enthusiasts of any caliber.
Credits & Licensing
When modifying and flashing a vehicle, there is a required one time licensing fee. Check HERE to see what your vehicle will need for licensing. Universal Credits are the ONLY credits that the MPVI3 interfaces will take.
Need to view more data with your MPVI3 from a wideband sensor, boost gauge, or other additional sensors? Get equipped with the ProLink cable (sold separately), enabling users to wire in and record up to 2x
analog signals (from a wideband sensor, map sensor, etc.) and 1x CAN bus
signal simultaneously. Now standard with Pro Feature Set, MPVI3 is fully compatible with the PROLINK+ cable straight from the box.
*PROLINK+ is not required for MPVI3. The ProLink cable must be wired in for use.